LyondellBasell · Schulamid 6 GF30 H
A glass-fibre reinforced PA6 with additional heat stabilisation. The difference from standard GF30 does not show up in short-term strength but in ageing: the material retains its properties far longer at continuously elevated temperatures.
Rated 1 to 5 relative to the other materials in our range. This is an experience-based orientation aid, not a measured value – the hard numbers are in the table below.
| Property | Value | Source |
|---|---|---|
| Material class | Polyamide 6 (PA6) | grade designation |
| Reinforcement | 30 % glass fibre | grade designation |
| Special property | heat stabilised | CAMPUS datasheet |
| Density (ISO 1183) | 1.35 g/cm³ | CAMPUS datasheet |
| Tensile modulus (ISO 527) | 9,200 MPa dry / 5,000 MPa conditioned | CAMPUS datasheet |
| Stress at break (ISO 527) | 165 MPa dry / 100 MPa conditioned | CAMPUS datasheet |
| Elongation at break (ISO 527) | 3.5 % dry / 8 % conditioned | CAMPUS datasheet |
| Charpy unnotched, 23 °C (ISO 179/1eU) | 85 kJ/m² | CAMPUS datasheet |
| Charpy unnotched, −30 °C (ISO 179/1eU) | 60 kJ/m² | CAMPUS datasheet |
| Charpy notched, 23 °C (ISO 179/1eA) | 14 kJ/m² dry / 30 kJ/m² conditioned | CAMPUS datasheet |
| HDT A, 1.8 MPa (ISO 75) | 200 °C | CAMPUS datasheet |
| HDT B, 0.45 MPa (ISO 75) | 220 °C | CAMPUS datasheet |
| Vicat softening temperature (ISO 306/B) | 210 °C | CAMPUS datasheet |
| Fire behaviour (IEC 60695-11-10, 1.5 mm) | HB (UL Yellow Card available) | CAMPUS datasheet |
| Burning rate (ISO 3795 / FMVSS 302, 1 mm) | 30 mm/min | CAMPUS datasheet |
| Comparative tracking index CTI (IEC 60112) | 450 | CAMPUS datasheet |
| Drying before processing | 80 °C, 4 – 6 h | CAMPUS datasheet |
These values are taken from the manufacturer datasheet and apply to the material, not to the printed part. In 3D printing the achievable properties depend on part orientation, layer height and process parameters – in the Z direction in particular they are lower. Please talk to us before relying on them for design.
“Qualified for functional parts” is a general classification. A functional part can be a simple clip or a main load-bearing member – the forces and load cases differ fundamentally. We therefore always assess in each individual case whether a material is suitable for your part.
Source: LyondellBasell / A. Schulman, CAMPUS datasheet SCHULAMID® 6 GF 30 H · compiled 2021-04-08
Produced on: Bosch pellet printer — More about this machine
We are happy to advise on material selection and to review your part for manufacturability.
Send an enquiry
ZIKO